December Update and Redirection of Build Plan

This will be a large update, mainly changes to the design and build:

• Controller board will be Smoothieboard 5XC with additional stepper drivers
• Why? Smoothieboard works with current reprap hosts, 3d printer G-code, has Delta auto-calibration, is in a single kit, and is very easy to configure without learning Linux
• This means I am no longer pursuing the Beaglebone Black - CRAMPS + CRAMP3 setup
• 7" Samsung Galaxy Tab 4 will be the control panel
• This will replace the 9" resistive touch panel to control the board
• I can now use octoprint and print2peer etc to operate the machine
• As of now I'll need to wire up more stepper drivers to operate the 3d printer to use multiple filaments
• The E3D has problems with retracting out that far making clogging a huge issue because of stringiness, so I must combat that problems so only 2 extruders for now
• Belts will not run in the channel but rather behind the extrusions out of sight
• The extrusions now will be 2020 V-slot build or 2040 V-slot Wolfstock derivative

That's all for now!